Bathroom Vanity | Project Guide

Short answer: A bathroom vanity or cabinet must fit the basin, trap, tap, wall services and available circulation. Compare moisture protection, internal access, countertop, drawer clearance, fixing, sealant and installation responsibilities in the written scope.

A clear brief helps homeowners, designers and contractors compare like-for-like scope. This article addresses bathroom vanity for a Singapore project and separates general guidance from decisions that require a measured site and approved drawings.

Start with the finished bathroom

Measure after waterproofing and wall finishes are understood. Record basin dimensions, tap position, waste and trap, mirror, splash zone, door swing and service access.

Detail the wet-area interfaces

State the cabinet grade, thickness, edge treatment, ventilation, plinth or wall-hung fixing and countertop material. Ensure the installer can seal the wall and top correctly.

Keep the quotation itemised

Separate cabinet, basin, tap, mirror, countertop, cut-outs, delivery, installation and removal. Confirm what is supplied by each trade and who returns for adjustments.

Project checklist

1. Provide the floor plan or opening schedule, clear site photos, dimensions and target date.
2. List appliances, services, storage needs, access limits and building-management requirements.
3. Request samples, dimensioned drawings, a line-by-line quotation and written exclusions.
4. Confirm who measures, manufactures, packs, delivers, installs, protects and adjusts the work.
5. Keep the approved finish, drawing revision, care instructions and handover record.

Singapore guidance and evidence

BCA PUB. These sources are useful starting points, but current requirements depend on the property, product and scope. Ask the appointed professional or building manager to confirm what applies before ordering.

FAQ: bathroom vanity

Can one photo or a catalogue price confirm the answer?

Usually not. Photos help with an initial review, but measurements, services, access, materials, hardware and installation responsibilities are needed for a dependable decision.

What should I compare between suppliers?

Compare the same dimensions, quantities, specification, finish, hardware, delivery and installation scope. Ask each supplier to state exclusions and the process for changes or defects.

What is the next step?

Send the drawings, photos, site location, preferred finish and target date through the ForgeWin contact page for a project-specific review.

Reference note: BCA PUB. Confirm current project requirements before fabrication or installation.